[AIOT] Console Debug for PE100A

ASUS Support FAQ

FAQ

Product PE100A, PE100A V2.0, PE100A V3.0

Please refer to the URL as below to set up PE100A

http://github.com/ASUS-IPC/ASUS-IPC/wiki/PE100A#33-switching-uart-protocol

Connect PE100A to a PC with a USB serial cable

On Software setting

i. Type “PE100A-config” in terminal to enter PE100A Software Configuration Tool.

ii. Select UART option.

iii. For RS232/RS422, select “1.RS232”. For RS485, select “2.RS485”.

iv. Select Serial option (item3) to enable serial kernel message.

v. Leave PE100A Software Configuration Tool than reboot device.

vi. Open Putty and select Serial on the PC, and the Serial line can be checked from Windows >Device Manager >Ports (COM & LPT). The speed is 115200 baud.

vii. To set up the putty log file

Was this information helpful?

Yes No

Contact Support

Please contact with us if the above information cannot resolve your problem

Above information might be partly or entirely quoted from exterior websites or sources. please refer to the information based on the source that we noted. Please directly contact or inquire the sources if there is any further question and note that ASUS is neither relevant nor responsible for its content/service
This information may not suitable for all the products from the same category/series. Some of the screen shots and operations could be different from the software versions.
ASUS provides the above information for reference only. If you have any questions about the content, please contact the above product vendor directly. Please note that ASUS is not responsible for the content or service provided by the above product vendor.
Brand and product names mentioned are trademarks of their respective companies.

ASUS Support FAQ

南宫28

FAQ

Was this information helpful?